Ok, i have an appointment to get the valve adjustment monday morning.
I'll line up some biobor as well.
Here's a question about the fuel lines in engine bay...
It seems like the short line feeding the pre filter is a bit bent. Not quite kinked and definitely not pinched, but is this bend going to cause some lack of flow? This is the physics that i don't quite understand with fluid motion. Would it be unwise to lengthen the replacement segment by perhaps around an extra 4 or 5 inches so that there is some gradual bend instead of a tight bend? Or would this completely throw off the balance of fuel flow to alter the OEM short hose length feeding pre filter....