Rick, the wires are on the low pressure switch which is located on the top of the receiver/dryer on the right front end of the engine compartment just under the forward edge of the ABS unit. There are two spade clips encased in a black rubber insulating material. The spades on the switch are pointing upward. Start it up, select max A/C, remove the two leads from the switch and connect them together. If the compressor comes on then you are either low on R-12 or your switch is bad. Hopes this helps..

------------------
Jeff Lawrence
1987 300e
1989 300e
2000 Dodge Grand Caravan SE

[This message has been edited by jeffsr (edited 08-17-2000).]