There was a message from the foxwell I didnt understand, no communication from SY...Something. It does say the level sensor has no signal, maybe this is why and perhaps the burned pump took this computer out?

My update is that I was asked by Arnott to bench test the pump and I did without removing it. I pulled the power leads and with alligator clips supplied 12 volts and the pump ran great and pressurized the system until it popped the relief valve. No hissing anywhere, and its at nice full ride height! And no more error message. So something is indicating the car is level.

I didnt realize the suspension was controlled by a separate computer, I was going to order ride height sensor..I will pull the cover and give that a check and then look into the computer. Thanks again tjts1

Its just so nice to have it off the bump stops and not reading the error too low again!