Thanks for the reply Frank, I have been out actually working on it today. All power and grounds are good. I checked them before I started the vehicle and after it stalls out. Fuel pump is working great and has never shut off since I installed the new one. I checked all temp sensors and they are within specs. The only thing that I found that was at aspects was the map sensor second coil. I had 0 ohms when I tested it. So I remove the plug clean the terminals and plugged it back in and now I am showing just about 500 ohms which I think is pretty close to specs. One thing I did notice is it is not holding vacuum though. Not knowing these vehicles very well I'm not sure where the map sensor could be causing it to stall when it warms up and not let it start back up for a while?