|
Further attempts to get the stud into the knuckle have been unsuccessful - I think the jackstand is not close enough to the ball joint - please see attached picture. Regardless of assumed strategy (car on jackstands + jacking up the LCA, jackstand under LCA and lowering the vehicle on the jack, all combined with diagonal jacking to shift the weight forwards), the stud does not go further into the knuckle. I have of course changed the position of the knuckle relative to the stud multiple times, even got it at the right angle, all to no avail.
I am considering two scenarios:
1) Loosen the sleeve further (I did pry it open some and cleaned out the sealant that I have applied during the previous installation) and loosen the LCA bushing bolts - I don't think they exert that much force on the assembly, but l'm theorising that this might give that small bit of upward movement I am lacking here.
2) Jack the LCA up, remove the tyre, put a jackstand much closer to the ball joint and CAREFULLY lower the jack. Obviously, I am a little hesitant about this option.^
Thank you for all the help so far, further suggestions are most appreciated.
|