Hey Tinker,


Never done a leak down or pressure down test before. I don't even know what it needs to perform this test. I did a compression test and as I stated before that cylinder number two is low and out of spec.

I'm in the middle of moving, and you know it is very hectic. I can't spend too much time on this car, I need to pack the kids and wife, buy a house, and sell a house, and lots of other fun stuff.

I order a new Bosch potentiometer for the air mass sensor and will give it a shot before I have it tow to the dealer. Any one have some advice for what nominal resistance for me to set before I install the pot???

Thank you
Alex