|
OK, I got it built... but I just noticed I got the wrong connectors put on the ends. I thought the tiny 3/32 Mono phone plugs would fit into the holes of the 38 pin (X11/4) diagnostic connector.. I was wrong.
I just noticed that on the module that has the LED display, there is a spot that I can tie into the #1 and #3. I tested it and it has just under 12 volts, so that must be tied directoy to the X11/4. I can use the banana plugs for those.
I'll have to figure out how to get the 3rd plug (yellow) into the x11/4... maybe I can use something thin like a paper clip and then use an alligator clip (in place of yellow) to grab the clip.
|