Here is an update, maybe this might help in solving the problem. I know someone has the answer to the 4 codes.

I went to the car and I was looking at MASS, I discovered the big 5-6 " Tube or whatever it is called (Air Filter to Intake Manifold) is disengaged from the part that is going back towards the engine intake 3-4 inches just before it makes a right turn.
------- Rear Engine intake Snug fit to the engine, But can be pulled
-------
l l
l l
l l <----tube DISENGAGED just touching it loosely no clamp no fit
l l end of the Mass sensor Clamped good
llll Mass Air sensor
l l Clamp and fited good
l l
-----
l l Air Filter box
-----
Below is the explanation:

So..from the Air filter to Mass it is snug fit with a clamps, the 2nd end Mass part is also connected well.

**Problem is, I dont know if this is the way it supposed to be.. but that part after MASS is just touching the other part which continues to the engine 3-4 inches before it make a right turn towards the intake is Loose nothing connecting the two it is just touching it, if you touch it you can see inside Both pieces have ARROW impression <---- pointing to the 2 tubes ----><-----.... . I think it should have some sort of clamp, I tried to put the rubber into the other piece to make a connection, but it wont go in.. **

**further down the engine where it connect to the engine, I noticed I can turn that piece, I dont know if there is also a clamp in the back of the engine. I can even pull it out. However, it is inside and a snug fit. But it can be pulled out by hand.**

If you take the engine MB LOGO plastic piece off you will see what i am talking about in the back rear intake manifold.

Any suggestion, before I head out to the dealer? And start changing MASS, p0173, p0170... and p0700 p0730 code (transmission)

Could all this be realted to the part not being connected for all 4 code, or this is just another seperate thing..


Thanks again.