Sorry, I didn't take any photos. However, the X48F connector is actually a simple connection of the power and ground to the 3 actuators (left door, right door, and trunk) and the central locking pump.
To get to it, you need to remove the back seat and peel back the carpet in the right rear foot area. The wiring harness is located in a plastic U shaped channel with a snap on cover. You need to un-snap this cover and unravel the harness insulation. You will eventually find these connectors located in the somewhere in the middle. When I found mine, they were transparent in color with green corrosion inside. The corrosion was so bad, that I could pull apart the wires easily.


1987 300D 185Km
2001 CLK 430 Convertible 27Km