before I attempt this...

Does someone have a good writeup. I am sure there was one floating on the web-but I cannot find it today.

I had just removed the bottom plate and was going to do the clean, flux, and remelt the solder. Then post clean with alcohol again.
One of the pins looks a little melted- pin 12 on the tempture dial side. It's got loose solder above the board somewhere.. I'd like to take it apart further and remove FOD.



Michael

__________________
Michael McGuire
83 300d
01 vw A4 TDI
66 Chevy Corsa
68 GMC V6 w/oD
86 300E