|
Garret
The tool MB wants you to use is an old M110 engine valve adjusting wrench. It's an open end 17mm wrench that you use on a groove in the metal end, then you can pry it against the valve cover to lever off the plug wires from the plugs. Works pretty slick. A normal 17mm open end won't work, this tool has a pretty deep offset and aloows you to get in there.
Tom says a plug wire pulling pliers worked for him, i would imagine it has a pretty steep angle to it, beacuse there isn't a whole lot of room to the sides of the engine.
Gilly
|