Howdy,

OK, on to my next W201 adventure. While I was under the car changing out tranny fluid, I checked the driveshaft center support bearing and found that it is shot. The rubber buffer around the bearing is done and the driveshaft can move around.

Is this in any a DIY repair? What is required? I'm pretty handy, but I don't have the big wrench needed to remove the nut on the end of the front shaft.

Thanks much.

Sholin

'84 190D 2.2

__________________
What else, '73 MB 280 SEL (Lt Blue)
Daily driver: '84 190D 2.2 5 spd.