|
On the top picture, that is part of the bar itself, so it stays attached to the torsion bar.
On the second picture I belive that stays put, can you post a picture at a different angle? I don't remember taking that off.
Maybe I did though, is that like a strap that surrounds the torsion bar? If so, just remove it.
To disconnect the torsion bar, you need to hammer that large hex-shaped tube to the rear of the truck. I'd use an air hammer with a chisel tip on it, they'd slide back pretty easy when the bar was unloaded. The tube is just a coupler between the bar and the control arm, you only need it to slide back enough to disengage from the control arm.
Gilly
|