Quote:
|
Originally Posted by mdsjsb
It was a typo. blk = 1; red = 16; other = 8
SInce the engine is running so rough ( 4 cylinders I think)
Could I just let it idle in the driveway to satisfy the "run for a day"
to pick up any faults.
Arthur: thank you for all your input.
jsb:
|
OK . I figged a typo , but wanted to make sure before we get in trouble here....
Only on four .. you now have an E220...[bg]
OK
Clear out the junk codes and as soon as you get a 1 flash on pin 8 , then push the button again for 8 secs, turn of key for 2 sec, on for 50 , and start.
This will reset/reactivate the module ...
See what you get after that.
Also go get pin 14 and the built-in sw/led one.
Just list the codes and what pins, not the whole procedure, if u don't mind