Pin 8
Code 4 (Hot Film MAF sensor air flow implausibly low/open circuit)
Code 9 (O2 sensor voltage too high/implausible/cold or open circuit)
Code 13 (O2 system operating at rich limit or lean limit)
Code 44 (CAN commucnication from EA/CC/ISC control module defective/CAN communication from diagnostic module defective)

Pin 14 ASR
Code 2
Code 9 (Hall effect speed sensor)

Pin 14 Without ASR
Code 2
Code 9 (Rear axle VSS sensor/Incorrect CC/ISC control module installed/ETS Signal)

Appears that you may have Incorrect CC/ISC control module installed if your car is without ASR.

I was getting Pin 8 Codes (13 & 20), DM Codes (3,4 & 19), Pin 14 Codes 7 & 14. (With ASR)

Replacing the Engine Control Module took care of all the codes and the check engine light. I did not have any drivability problems at all, just did not like the check engine light on.

Arthur Dalton will be able to point you in the right direction, he is the expert on these systems and is very helpful.

__________________
Zafar
94 E320 58000 Miles