I need to do the exhaust on the SDL sometime soon. Some questions:

1) I presume that you keep the factory downpipe with the flex coupling built in.

2) What tubing did you use to go from the downpipe to the muffler? Was this commercially available? Who bent it properly?

3) I presume that you eliminated the center muffler, just forward of the rear axle and just to the driver's side of the vehicle.

4) What are the details of the flowmaster muffler? What is the expected life of this component?

5) What's the cost for the system from the back end of the downpipe to the end of the system?

6) You mention a cat on the system. I cannot seem to find any evidence of a cat on this one. That is, unless I am calling the cat the center muffler. It is awful small for a muffler and awful big for a cat. As mentioned above, it lives just forward of the rear axle on the driver's side.

I'm weighing a complete stainless steel system from Timevalve for $650. or so. But, this is a bit pricey and I was looking for alternatives.

Thanks.