In order to do a good runout test, do the rotors need to come out? I imagine there is some kind of device they need to be inserted into in order to keep the rotor and micrometer stationary while the rotor spins around.
J
Quote:
|
Originally Posted by boneheaddoctor
Tie rods are only part of your problem, did you do a runout test, I'll bet you have warped rotors also.
OH, and while you are under it check the other dust boots on the Ball joints and center link too. If those are bad you should do them all at once. Alignments do cost quite a bit more than $10
|