I am working on my Girlfriends 94 E320. It has the HFM mangement. I had the head milled, cleaned the block mating surface installed a new gasket, and all associated hardware. I marked everything when I took it apart and am sure that the wiring and vacuum lines are all correct.

However, the engine turns over but does not start. I checked the compression with a crappy old gauge and it was reading a little low, but not bad. I think this was from the gauge.

ANyway, the engine has spark on at least three of the plugs. I believe the car is getting fuel (its pressurizing the fuel rail).

I don't know what else to do!

Thanks,
Rob