i again worked on my hard start problem today and would like to check the duty cycle. however, i could not get my initial readings correctly.

At KOEO, I noticed the LED in X92 is continously on. Pressing the push button for 2-4 sec does not make a difference. I was trying to switch over to on/off ratio output mode and meassure duty cycle at X11. Nonetheless, when I measured X11 at pins2-3, I got 97.6% duty cycle ( using sears VM), and 1.9V. I am stuck here and cannot move forward with testing.

Can someone point out what I am doing wrong? and why the LED at X92 is continously on?

thx,
emmy