I'm planning on replacing the pre-chamber seals on my 300D and I was wondering if anyone has done the same and if there's anything to pay particular attention while doing it. I bought the tools recently so it shouldn't be too hard.
I think I have a leaking seal on #5 cylinder since the compression reading was lower on it than the rest. I've seen some bubbles around the ring when I had a fuel leak on that injector so I'm assuming I need to replace it. I plan on replacing all the seals while I'm at it, if they're not too expensive. I'll also clean and inspect the prechambers at the same time as well.

__________________
DJ


84 300D Turbodiesel 190K with 4 speed manual sold in 03/2012