|
I show 55nm, then 90 degrees and another 90 degrees, again you do these in stages, tighten them to 55nm in the shown sequence (I assume you have the sequence), then turn them all 90 degrees in the same sequence, and then again 90 degrees in that sequence. I show the front hex bolts at 25nm, I assume these are done at any time, I'd do them right after the big bolts are tightened to 55nm, then recheck after each angle torquing is done.
edit: recheck front bolts after each SERIES of tightening is done, not every bolt
Gilly
Last edited by Gilly; 06-25-2005 at 06:00 PM.
|