View Single Post
  #4  
Old 07-15-2005, 01:24 AM
Todd Miller's Avatar
Todd Miller Todd Miller is online now
1966 250SE Coupe Owner
 
Join Date: Jul 2005
Location: San Luis Obispo, CA
Posts: 670
Here's the method I use on heavily rusted and even pin-holed fuel tanks.

Drain and Remove tank.
Pressure wash the inside.
Pour in a quart of muratic acid (sold at any hardware store) and very slowly "slosh" around in the tank......This is some super methyl-ethyl-bad-***** so be sure to where goggles, gloves and a real respirator.

As the muratic acid works, it will eat all the rust out AND it will be smoking in the process! Give it 10 minutes or so to cook and then start filling the tank with water.

Pour all of this out......good for weed abatement and fence post protection, etc.

Now rinse thoroughly with water and blow dry with compressed air.

Pour in a quart of denatured alcohol to absorb any left over water.

Pour out the alcohol and dry with compressed air.

Let it sit in the sun and dry for a few hours or a day.

You'll be left with a very clean and shiny tank.

Now; if you have rust holes and/or heavy rusted 'shale' in the tank, you can seal the tank permanently with "RedKote" fuel tank reliner. This is an aviation quality "liquid vinyl" type compound that you pour in, slowly slosh around to coat the entire tank inside and then pour off the excess. This stuff dries in 24hrs and is absolutely bullet proof after that. If you have holes, tape over them on the outside so the RedKote has something to park against while it cures. Then peel off the tape in 24hours and paint the outside of the tank! If you had rust, sand, crud, 'shale', etc. in the tank, it will be permanently sealed in place....forever.

The only drawback to Redkote is that you must be careful not to seal off vent pipes, fuel pickup pipes or screens, internal baffles, etc. Once this stuff dries, that's it, your screwed. So, go out of your way to keep important things open and clear.

I've done 4 or 5 tanks like this with fantastic and permanent results.

Now in your case where you just have some funky fuel living in there, you may not need to be so agressive. You may be able to just pull the tank, pour out the bad fuel, slosh some carb cleaner around, pour off, dry with compressed air and be done.
Reply With Quote