|
The relatively high O2 content on the 15 MPH test indicates that the catalyst was WAAAY too cold, which means you need to pay close attention to "conditioning" prior to submitting the car for test. I discuss this in the referenced threads.
Even with only 0.1 percent O2 at 25 MPH the HC is still high but if the catalyst was efficient enough to use all of the O2 the HC would probably be within the limit, but it will be tight. The key is to ensure the cat is hot enough to meet the 15 MPH numbers. In that case the 25 MPH test is usually no problem.
Owners who want to get these cars through emissions without spending inordinate amounts of money for "fixes" should understand how to check and adjust the duty cycle and how to check the O2 sensor. Both have been discussed extensively on this forum (use the search function) and service manual data sites.
My gut level feel is that your duty cycle and O2 sensor are probably okay. The primary issue is proper pre-test conditioning, and if the cat needs a little help to get hot you can use the referenced links to retard the ignition timing by judicious tweaking of the centrifugal advance curve (short the R16/1 pigtail) and block the vacuum advance.
If it currently has resistor type plugs, don't even THINK about a retest until you install the proper non-resistor Bosch Super H9DC (NOT HR9DC).
Duke
|