Quote:
|
Originally Posted by coachgeo
..yet the seat wont seperate from the frame that attaches to the floor,...
|
There is your problem, you are unbolting the wrong bolts! Just simply unbolt the entire frame that bolts to the floor.
Quote:
|
Originally Posted by coachgeo
Did you only pull the black seat mounts off of the floor and not take the seat itself off of these mounts? If so do you have access to all of the insides of the bottom seat this way?
Up position? you mean most verticle position or? How do they unplug? I cant see how they do at the moment. Maybe after moving the seat upright it will make since.
As to my search earlier. I found no threads on the removal of these seats.
Can I install the seats from my 300D into my SD? They are fine
|
I mean that the bottom part of the seat was as far up (towards the headliner) as possible. This allowed me to access the wiring harness much easier. There are just three plugs, the outer one (towards the door) is about 12 prongs and the whole plug just pulls off. One nearer to the tranny hump is only 4 prongs and pulls off. And finally one that is loose that is only 2 prongs that you have to squeeze the sides of the connector to get undone.
After that, the seat comes out, and you cane access the bottom of the seat enough to stuff noodles in there. I think it may be hard to access the actual springs this way though.
In someones experience, how long will the noodles last before they need replacing?