Quote:
|
Originally Posted by sbreisch
I'll take a look tonight when I attempt this job again. It looked like the turn signal lens is just held in by two tabs that slide out and not any nuts etc to turn? Maybe I just didn't notice last night. I couldn't even get near or see near anything around the turn signal to loosen or press on a tab.
Thanks,
Steve
|
Look from the inside of the engine comparment, there should be a plastic tab/clip that will release the TS assembly and it slides out in the forward direction. New one should just be installed lining up the two tangs you see with the slots and sliding into position until you hear the tab/clip "click"