|
|
|
|
|
#1
01-05-2005, 11:02 PM
|
||||
|
||||
|
The oil cooler on my SDL has been bypassed...
Instead of there being an oil cooler at the end of the two oil cooler hoses, there was a piece of pipe and the cooler lines were connected to each end of that pipe. The crimped part of each hose had been cut off and each was secured to the piece of pipe by 2 hose clamps. The pipe had 2 bends in it so it isn't straining the hoses and the pipe is being suspended by zip ties to keep from rubbing.
Do you guys think this will hold? Neither of the junctions appear to be leaking. I'm not too worried about the oil getting too hot (I have Delvac 1 in now, not that it matters) but I don't want the hoses to blow off and my engine seize. Thanks David
__________________
_____________________________________________ 2000 Honda Accord V6 137k miles 1972 300SEL 4.5 98k miles _____________________________________________ 
|
| Bookmarks |
|
|
Threaded Mode
