|
|
|
#1
|
|||
|
|||
how do you measure...
...the length of the throttle linkage levers???From center to center of the holes or from end to end???The rep.manual says 20,5cm but doesn`t say which way to measure..It`s the one that goes to the butt bolt of the IP.Engine is om621.918,I believe 615,616 have similar setup...
Thanks a lot! Vengerov ,w110 200D `67 |
#2
|
||||
|
||||
Hmmm
Center to center, if I recall correctly.
I think the last one I measured was 1978.
__________________
ASE Master Mechanic asemastermechanic@juno.com Prototype R&D/testing: Thermal & Aerodynamic System Engineering (TASE) Senior vehicle instrumentation technician. Noise Vibration and Harshness (NVH). Dynamometer. Heat exchanger durability. HV-A/C Climate Control. Vehicle build. Fleet Durability Technical Quality Auditor. Automotive Technical Writer 1985 300SD 1983 300D 1984 190D 2003 Volvo V70 2002 Honda Civic https://www.boldegoist.com/ |
Bookmarks |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
How to Measure Blowby | veg_burner | Diesel Discussion | 59 | 06-11-2006 10:48 PM |
what does the temp. gauge measure? | jblackbu | Tech Help | 6 | 12-02-2004 08:06 PM |
Frist: Tax-returns measure indefensible | GermanStar | Off-Topic Discussion | 19 | 11-23-2004 10:18 AM |
So where exactly do you measure the pistons? | jassz | Diesel Discussion | 16 | 03-09-2004 04:58 PM |
Newer Mercedes Quality | chronodeco | Tech Help | 31 | 03-08-2004 02:50 PM |