|
|
|
|
|
|
|
#1
12-22-2005, 06:36 AM
|
|||
|
|||
240D manual transmission question
I was looking up clutch parts at napaonline.com and they claim that this transmission has an 1 1/8" 10-spline input shaft.
Is this correct?  I thought for sure that it would have been a metric size. I hope that it's true, 'cause it'll make my entire project a LOT easier! 
|
|
#2
12-22-2005, 07:28 PM
|
|||
|
|||
|
Nobody can verify this one way or the other?
Don
|
|
#3
12-22-2005, 07:53 PM
|
||||
|
||||
|
I have never measured it, just stuck it in
 I can tell you that I use an input shaft from an old Volvo tranny for an alignment tool when installing clutchs, same size. __________________
__________________
 1985 Euro 240D 5 spd 140K 1979 240D 5 spd, 40K on engine rebuild 1994 Dodge/Cummins, 5 spd, 121K 1964 Allice Chalmers D15 tractor 2014 Kubota L3800 tractor 1964 VW bug "Lifes too short to drive a boring car"
|
|
#4
12-22-2005, 10:12 PM
|
|||
|
|||
|
Quote:
|
|
#5
12-23-2005, 02:33 AM
|
|||
|
|||
|
Well the Sachs catalog also says it's 1 1/8" by 10 splines.
It just sounds too good to be true! I thought for sure it would be an off-the-wall metric size of some sort.
|
|
#6
12-23-2005, 11:50 AM
|
||||
|
||||
|
"Well the Sachs catalog also says it's 1 1/8" by 10 splines"
Thats right, I just measured one out of a "78" 240D
__________________
1985 Euro 240D 5 spd 140K 1979 240D 5 spd, 40K on engine rebuild 1994 Dodge/Cummins, 5 spd, 121K 1964 Allice Chalmers D15 tractor 2014 Kubota L3800 tractor 1964 VW bug "Lifes too short to drive a boring car"
|
 |
| Bookmarks |
|
|
Hybrid Mode
