|
|
|
#1
|
|||
|
|||
Air Cleaner Rubber Mount Heat Shield Orientation
This may be a retarded question, but what is the proper orientation of heat shields on the rubber mounts? Cup side up, or cup side down?
__________________
B - 1983 300SD |
#2
|
|||
|
|||
The heat shield sits like a cup with the support mount stuck through it keeping it locked down in place.
So, cup side down, I guess.
__________________
1982 300CD Petrol/Black Leather |
#3
|
|||
|
|||
Quote:
So flat part down, with the opening up. Got it. Now if I can just get that bottom 13mm bolt out...
__________________
B - 1983 300SD |
#4
|
|||
|
|||
Quote:
I just did mine, after some messing around I got the 13 mm bolt out by using a 13 standard socket with a universal joint and an extension (about 12"). I got to it from the front (too much angle from the back) and was able to push the socket into the bolt fairly hard while turning it. I found the socket wants to jump off the bolt if you don't push it on pretty hard while turning. I probably wasted 20 minutes messing with it before I found the best angle. It's a PITA, but it's do-able. BTW, where are you located? |
#5
|
|||
|
|||
Quote:
__________________
B - 1983 300SD |
Bookmarks |
|
|