|
|
|
#1
|
||||
|
||||
Ebay reciever hitch for 123 sedans
http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&ih=012&category=33653&sspagename=STORE%3APROMOBOX%3ANEWLIST&viewitem=&item=220052988552
They look like this: And somehow have to mount to this: I sent them a question asking if they had installation instructions, and if it came with bolts. Mark
__________________
1983 300CD 245K Running WVO blends |
#2
|
||||
|
||||
The auction also said
"NOTE:: MAY NOT BE EXACT PICTURE OF CUSTOM FIT HITCH FOR YOUR VEHICLE so you should ask whether the Mercedes hitch is the same as the one in the picture. $40 shipping to California.
__________________
"Buster" in the '95 Our all-Diesel family 1996 E300D (W210) . .338,000 miles Wife's car 2005 E320 CDI . . 113,000 miles My car Santa Rosa population 176,762 (2022) Total. . . . . . . . . . . . 627,762 "Oh lord won't you buy me a Mercedes Benz." -- Janis Joplin, October 1, 1970 Last edited by Jeremy5848; 12-20-2006 at 11:22 AM. Reason: Add shipping cost. |
#3
|
||||
|
||||
The one pictured doesn't look like the one installed on the car....
__________________
Jimmy L. '05 Acura TL 6MT 2001 ML430 My Spare Gone: '95 E300 188K "Batmobile" Texas Unfriendly Black '85 300TD 235K "The Wagon" Texas Friendly White '80 240D 154K "China" Scar engine installed '81 300TD 240K "Smash" '80 240D 230K "The Squash" '81 240D 293K"Scar" Rear ended harder than Elton John |
#4
|
|||
|
|||
The mounted one pictured looks like what I have.
I believe a have an extra one around here somewhere... I'll get a shot of it if you need it. |
#5
|
|||
|
|||
notice the size of the square. its 1-1/4". pretty small but ok for say a small utility trailer. i had a similar one put on my 190d (?) quite a few years ago and pulled a pop up tent trailer with it. it worked good. i had a very good welding shop install it, and they welded it where you would need it welded and it became a light weight equalizer hitch.
this one shown is quite typical for a non-frame vehicle (looks like the one i had on my plymouth mini-van and my rabbit diesel) and would most likely be just bolted to the trunk floor pan and attached with bolts and large flat washers to spread the "load " of the mounting bolt to the good sheetmetal. davidh
__________________
david h 83 300D Alabama Beauty (Son's) 83 300D West Coast Rust Free that been abused |
Bookmarks |
|
|