|
|
|
#1
|
||||
|
||||
fianlly got rid of EGR!!!!!
well today i finally got around to removing my egr this evening.I used sheet metal and jp weld to finish it up.
just one question. I just pulled the 2 vacum lines from the "temp sensor"?, it is ok to leaave it at that " meaning the 2, 3/8 inch peaces are just sitting exposed, or should i plug them -thanks
__________________
82' 300SD |
#2
|
||||
|
||||
plug them.
edit: nevermind, I thought you were talking about the line going to the EGR.
__________________
-justin 1987 300TD, 1987 300TD 2008 R32, 2000 Passat Wagon |
#3
|
||||
|
||||
I would have used copper RTV sealent.. JB weld really isnt going to hold up to the heat..
|
#4
|
||||
|
||||
#5
|
|||
|
|||
Now, wouldn't you have preferred a nice clean installation like this?
I can help you with that........ |
#6
|
||||
|
||||
iknow, iknow, but my setup actually looks just like that on the exhaust port, i went out tonight and got some sealent for manifolds, and continued my install at 9:30 at night in the snow,fun!fun!fun!
__________________
82' 300SD |
#7
|
|||
|
|||
That is a thing of beauty right there. I want one. Right now I've got a piece of scrap I pulled off an extra dryer vent that I cut into the gasket pattern and mounted inbetween the ugly thing. But that right there is nice.
|
#8
|
|||
|
|||
EGR kits
Brian,
When will the new order be ready? Chris
__________________
1987 300TD 309, xxx 2.8.2014 10,000 mile OCI Be careful of the toes you step on today, as they may be connected to the ass you have to kiss tomorrow. anonymous “Be who you are and say what you feel, because those who mind don’t matter, and those who matter won’t mind.” Dr. Seuss |
#9
|
|||
|
|||
Figure late March......early April time frame........
|
Bookmarks |
|
|