I am looking for the out side diameter of the test sleeve for the linkage that bolts to the top of the valve cover on my 300 sd. The manual shows it to look like a small round sleeve that fits over the pins on the plate that the linkage pivits on. It is used to set up the injuction pump/transmission linkage. If some one has this tool and could measure the diameter of it for me.

Thanks Mark

Um, ... What?
do you have more details, and or an explanation of what this is. us noobies wanna know!
John

__________________
John HAUL AWAY, OR CRUSHED CARS!!! HELP ME keep the cars out of the crusher! A/C Thread
"as I ride with my a/c on... I have fond memories of sweaty oily saturdays and spewing R12 into the air. THANKS for all you do!

My drivers:
1987 190D 2.5Turbo
1987 190D 2.5Turbo
1987 190D 2.5-5SPEED!!!

1987 300TD
1987 300TD
1994GMC 2500 6.5Turbo truck... I had to put the ladder somewhere!

Are you talking about the trans modulator test disc?? See post #17 for link to dimensions.

http://www.peachparts.com/shopforum/showthread.php?t=152083

__________________
The Golden Rule

1984 300SD (bought new, sold it in 1988, bought it back 13 yrs. later)

The disc goes over a pin on the control lever on top of the valve cover so the linkage can be adjusted it spec. My mb manual calls the part an(adjusting sleeve) mb part number 180 072 03 93
It seems to be an important part when setting up proper funtion of the transmission.
Mark

I am looking for the same dimension!

__________________
Did you just pass my 740 at 200 kmh in a 300SD?????

1978 300SD 'Phil' - 1,315,853 Miles And Counting - 1, 317,885 as of 12/27/2012 - 1,333,000 as of 05/10/2013, 1,337,850 as of July 15, 2013, 1,339,000 as of August 13, 2013



100,000 miles since June 2005 Overhaul - Sold January 25th, 2014 After 1,344,246 Miles & 20 Years of Ownership