Hi all,

I've just replaced the rear seats in my 84 300sd and I have a small problem.
On the upright section of the seat, the material is loose from the seat at the
top, and it is pulling out of the crack between the seat and the package
shelf. I can't seem to see anything to hold the material to the seat frame.

How does this attach so that the material doesn't pull out of the crack and
look bad?

Thanks

__________________
Will W - 1984 300SD federal

It's stapled to the cardboard bar that holds it in position in the metal groove.

__________________
[/SIGPIC]~cirrusman

1983 Mercedes Benz 300SD - Wife calls him "Chitty Chitty Bang Bang"
[SIGPIC]




1983 Toyota Tercel (Tommy, The little Toyota that could)
1965 Ford F100 (Grandma Ford)
2005 Toyota Sienna (Elsa, Wife's ride)


Gone:
1988 Toyota Pickup
2004 Subaru Outback

1987 Cadillac Fleetwood Brougham
1986 Volvo 740 GL Station Wagon - Piece of junk.
1981 Volvo 242 DL 2 Door - Hated to see it go. R.I.P.
1987 Pontiac Fiero GT

> It's stapled to the cardboard bar that holds it in position in the metal groove.

I see the cardboard bar, but the metal grove is hiding from me :-)

__________________
Will W - 1984 300SD federal