|
|
|
|
|
|||||||
 |
|
|
LinkBack | Thread Tools | Display Modes |
|
#1
03-22-2014, 07:09 PM
|
|||
|
|||
|
Spec Needed: Plugging W126 OM603 Dipstick hole. Need size to source expansion plug
Installing a 3.0L OM603 into a W140 chassis, a 1994 S350. The W140 oil pan uses a side mounted dipstick. So, I need to plug the front mounted hole behind the alternator bracket. Anyone have an idea on this? The engine is far away, so if anyone knows an approximate size, I can buy plugs in a range around that size.
Thanks guys!
__________________
1987 300SDL #1, 1987 300SDL #2, 1980 240D, 1982 300SD, 1994 S350, 1990 350SDL, 1991 350SD, 1985 300D, 2005 E320CDI Gone, but not forgotten: 1981 300SD, 1982 300SD, 1987 300SDL, 1983 300TD, 1980 300CD, 1981 300SD #2, 1987 300D, 1987 300TDT, 1980 300D 
|
|
#2
03-22-2014, 07:13 PM
|
|||
|
|||
|
Basically, if anyone has a front of engine mounted dipstick tube, I just need to know the OD. That's a much simpler request...
__________________
1987 300SDL #1, 1987 300SDL #2, 1980 240D, 1982 300SD, 1994 S350, 1990 350SDL, 1991 350SD, 1985 300D, 2005 E320CDI Gone, but not forgotten: 1981 300SD, 1982 300SD, 1987 300SDL, 1983 300TD, 1980 300CD, 1981 300SD #2, 1987 300D, 1987 300TDT, 1980 300D
|
|
#4
03-28-2014, 07:59 PM
|
|||
|
|||
|
Sweet! Thanks!!
__________________
1987 300SDL #1, 1987 300SDL #2, 1980 240D, 1982 300SD, 1994 S350, 1990 350SDL, 1991 350SD, 1985 300D, 2005 E320CDI Gone, but not forgotten: 1981 300SD, 1982 300SD, 1987 300SDL, 1983 300TD, 1980 300CD, 1981 300SD #2, 1987 300D, 1987 300TDT, 1980 300D
|
|
| Bookmarks |
|
|
Linear Mode
