|
|
|
|
|
#1
03-12-2007, 09:35 PM
|
||||
|
||||
Inline A/C filter?
How does one install these inline filters?
 http://www.ackits.com/merchant.mvc?Screen=PROD&Store_Code=01&Product_Code=13128TSI&Category_Code=inlinefilters
__________________
I'm not a doctor, but I'll have a look.  '85 300SD 245k '87 300SDL 251k '90 300SEL 326k Six others from BMW, GM, and Ford. Liberty will not descend to a people; a people must raise themselves to liberty.[/IMG] 
|
|
#2
03-13-2007, 12:36 AM
|
||||
|
||||
|
You splice into the high side metal line, where there is at least 4" straight run.
5/16", 3/8", 1/2" lines will work. There is some "give" to the compression fitting flex sleeves if the line isn't smooth. Cut out a piece out of the metal line equal to the filter length, slip the compresion nuts , compression cones, flex rings onto the lines. Put the filter in the splice (arrow to flow) and tighten up the compression fittings.
__________________
The Golden Rule 1984 300SD (bought new, sold it in 1988, bought it back 13 yrs. later)
|
|
#3
03-13-2007, 07:52 AM
|
|||
|
|||
|
Yes, and you want it near the compressor inlet.
|
|
#4
03-13-2007, 11:22 AM
|
||||
|
||||
|
Hrm, any pictures or diagrams? This will be for my SD.
__________________
I'm not a doctor, but I'll have a look. '85 300SD 245k '87 300SDL 251k '90 300SEL 326k Six others from BMW, GM, and Ford. Liberty will not descend to a people; a people must raise themselves to liberty.[/IMG]
|
 |
| Bookmarks |
|
|
Linear Mode
