|
|
|
#1
|
||||
|
||||
1985 300SD - power seats help
Good morning,
I have a 1985 300SD that I recently purchase. I have one annoying little issue: The fuse for the power seats is continually blowing. I figure that the fuse may be too small for the load or that there is a short somewhere. What should the correct fuse be? And if I am looking for a short, where would be the best place to start? Thank you in advance for your help. Plantman 1985 300sd 175,000 1983 240d 83,000:: |
#2
|
|||
|
|||
are your springs OK?
Plantman,
I replaced the seat springs on my '87 SDL last summer. One of the springs (well actually 3 of the springs) had broken, as is typical. When one broke it sliced into the wires for the headrest. Blown fuse, no headrest movement. It was in a wire bundle under the seat. I'm sure this is only one of many possible solutions, but not one I would have guessed before seeing it. Chuck |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|