Hi,

I have my dawes boost controller, and have used my mityvac to set it to hold a max of about 10.5 psi (as per the 'official' chart posted in the archives, which shows about 725-750 mbar as the max spec pressure). This will be an improvement over the typical 8-9psi that I am currently getting. I am not looking for much sped improvement, my car goes pretty well, I just want to achieve that boost profile as per the manual, so I am at ful boost around 2k RPM, right when I need it for climbing an onramp that I typically drive on.

Anyway, before I go and cut the one and only wastegate hose that I have on the car, Id liek to know if the ID of said wastegate hose is the correct size to directly plumb the controller into.

The barbed ends on the controller look awfully small, and if some adapter is required, how did you set it up?

Any info would be really great.
Thanks,

JMH

P.S. The factory boost setting pic, from an older thread can be seen here:

__________________
Current Diesels:
1981 240D (73K)
1982 300CD (169k)
1985 190D (169k)
1991 350SD (116k)
1991 350SD (206k)
1991 300D (228k)
2008 ML320 CDI (199k)
1996 Dodge Ram CTD (442k)
1996 Dodge Ram CTD (267k)

Past Diesels:
1983 300D (228K), 1985 300D (233K), 1993 300D 2.5T (338k), 1993 300SD (291k)