![]() |
|
|
|
#1
|
|||
|
|||
107 Special Spanner For Front Seat Lock Pin
Gentelmen
When I got my 86 560SL both front seats would not fold forward. The reason was that the locking pin shown in the pictures below was loose on both seats. As you can see by the pictures, the locking nut that tightens this pin requires a special spanner. I have seen spanners like this before but I dont know where or how are they sized or is there a special MB tool number available anywhere. Anyone with any ideas. I would prefer not to cut flats in the nuts. John Roncallo Last edited by Roncallo; 08-06-2006 at 12:10 PM. Reason: Forgot pictures |
#2
|
||||
|
||||
Thats definitely an odd bolt.
Can you put something into the hole and then turn it?
__________________
-Justin 91 560 SEC AMG - other dogs dd 01 Honda S2000 - dogs dd 07 MB ML320 CDI - dd 16 Lexus IS250 - wifes dd it's automatic. |
#3
|
||||
|
||||
Use to have these type for bicycle repair....http://www.amazon.com/gp/product/B00063YSEU/ref=nosim/103-0995011-4475048?n=228013
.
__________________
[http://languageandgrammar.com/2008/01/14/youve-got-problems-not-issues/ ] "A liberal is someone who feels they owe a great debt to their fellow man, which debt he proposes to pay off with your money." |
#4
|
|||
|
|||
I think I stuck the ends of needle-nosed pliers in two of the holes and got it to turn.
__________________
Chuck Taylor Falls Church VA '66 200, '66 230SL, '96 SL500. Sold: '81 380SL, '86 300E, '72 250C, '95 C220, 3 '84 280SL's '90 420SEL, '72 280SE, '73 280C, '78 280SE, '70 280SL, '77 450SL, '85 380SL, '87 560SL, '85 380SL, '72 350SL, '96 S500 Coupe |
#5
|
|||
|
|||
I found it $15.59 derivered at.
http://www.bloomertool.com Its called a 25-28mm DIN Pin Wrench Thank you John Roncallo |
#6
|
|||
|
|||
I hound it again. The other place is out of stock.
http://www.jwwinco.com/ $18.65 for 2 delivered. or $18.87 for 1 deliverd. Yes that right. It cost more to buy 1 than 2 John Roncallo |
#7
|
|||
|
|||
Pin Wrench
I just reupholstered the seats in my 450SL. I used a pair of channel lock pliers to tighten the nut, but I wasn't able to get them as tight as I wanted. What is the part number for the wrenches you ordered?
|
![]() |
Bookmarks |
|
|