|
|
|
|
|
#1
01-10-2002, 06:06 PM
|
|||
|
|||
|
heater motor
Last winter my heater fan was noisy, so I opened up the cage and cleaned out the compartment and oiled the motor.
I could not get the complete unit installed in one piece so I put in the bottom then the motor then the top, but then I could not get all the clips back on, it's pretty tight in there. The ones I could not get to I used zip ties to fasten but now when I turn hard or hit bumps the fan rubs the case. Does any one have a trick to reinstall those clips, I have tried a needle nose, snap ring plier, and several other contraptions but still not got them in. jerryb 
|
 |
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| (astoundingly) another heater control/blower motor thread!! | kpb | Vintage Mercedes Forum | 18 | 02-02-2004 10:20 PM |
| W140 Blower Motor / Regulator Replace Together? | ddrake3 | Tech Help | 2 | 03-19-2003 12:36 PM |
| Any way to quiet down a heater motor on a 1988 300E? | Steve190E 2.3 | Tech Help | 5 | 12-07-2000 05:58 PM |
| 240D heater blower motor question (brushes?) | 240Joe | Tech Help | 1 | 12-04-2000 11:10 AM |
Linear Mode
