Parts Catalog Accessories Catalog How To Articles Tech Forums
Call Pelican Parts at 888-280-7799
Shopping Cart Cart | Project List | Order Status | Help



Go Back   PeachParts Mercedes-Benz Forum > Mercedes-Benz Tech Information and Support > ML, GL, G-Wagen, R-Class, Unimog, Sprinter

Reply
 
LinkBack Thread Tools Display Modes
  #1  
Old 12-02-2005, 07:42 PM
Registered User
 
Join Date: Feb 2001
Location: California
Posts: 392
Tire is wearing unevenly on the ML? How about yours.

Well if you read any of my previousing posting you will see that I had my wheels aligned about 7,000-8,000 miles ago and finally got new tires. And after the alighment they ML drove better (no pulling to the side ect). So I think the alighment is good.

But I recently rotated the tires myself and I found that the rear tires seem to wear out faster with more wear pattern on the outside edge (not to bad but still noticiable), the front was even less obvious

But the way I did not cross rotate should I have?

blau
__________________
Silver Honda Accord, 2006
Silver G500, 2003
Silver SLK-320, 2002
Black ML-320, 2000
Bule Porsche 993 Targa , 1997
Silver Merkur XR4Ti, 1987
Reply With Quote
  #2  
Old 12-02-2005, 09:49 PM
Ron in SC's Avatar
Registered User
 
Join Date: Aug 2003
Location: Charleston, SC
Posts: 1,095



Above is the rotation pattern I use. My second set of tires, Micheln Cross Terrains, had 62K miles on them when I replaced them with same brand. Rotate every 3500 to 4000 miles. Inflation 34 psi for all four tires.

They all wore evenly at the same rate.
Reply With Quote
  #3  
Old 12-02-2005, 10:02 PM
supradupe's Avatar
98 ML320
 
Join Date: Aug 2000
Location: North Shore, IL
Posts: 253
Quote:
Originally Posted by blau
But I recently rotated the tires myself and I found that the rear tires seem to wear out faster with more wear pattern on the outside edge (not to bad but still noticiable), the front was even less obvious

But the way I did not cross rotate should I have?

blau
Hey you are not alone. but first let me ask you how many miles do you have on your ML and are the shocks/struts original? I have similar issue with my 98 ML with 70k on the clock. I had an alignment done last year at about 64k and after about 5k miles of driving, I noticed the rear tires are wearing out on the outside faster while the fronts are still even. I did some searches on the internet and it seems the uneven wear is a result of the weak shocks on the rear. At 70k I am going to change them out and see if I could prolong the tires a bit. I too have the Michelin X-terrain and they are great tires. If your shocks are still original, this may be the culprit.
__________________
98 ML320 (gone but not forgotten)
Reply With Quote
  #4  
Old 12-02-2005, 10:18 PM
waybomb's Avatar
Registered User
 
Join Date: Nov 2002
Posts: 1,557
Check your rear upper ball joints while you are looking at things.


Edit - hey, this is post 500 for me! Do I get an award? Probably not, because most of my posts were questions. This is agreat board...
__________________
Thank You!
Fred
2009 ML350
2004 SL600
2004 SL500
1996 SL600
2002 SLK32
2005 CLK320 cabrio
2003 ML350
1997 C280 Sport
Reply With Quote
  #5  
Old 12-03-2005, 10:33 AM
Automotive Restoration
 
Join Date: Feb 2003
Location: Steamboat Springs, CO
Posts: 186
Glad to see this post now as I am having similar issues and looking for a good tire this time around - here's the short story and questions:

* Tires, Michelin Cross Terrain or Nokian? I saw both recommended under the Tires forum; I am in big time snow country, but let me say that my stock Dunlops were fine and the best wearing compared to the Bridgestones I went to next. All season's have worked for me year round even in the toghest on-road snow conditions - a tribute to the AWD.

* Currently Bridgestone Dueller H/T's are wearing as you have described here; first the rear's along the outside while fron'ts seemed fine. Now, the fronts wearing on the inside badly - this after a new tie-rod end and alignement, but no rotation. They look a lot worse than tires should with only 15K miles on them.

* My observation, once I started having alignments, I've had to have them annually - just coincidence or the shocks as you've mentioned because they are original with 112K miles? Are the shocks/struts a DIY? - I've read to take care with the springs as they are loaded with force.

A great forum I concur!
__________________
Francis E. Abate
Automotive Restoration & Preservation
Sheet metal, trim and upholstery
Reply With Quote
  #6  
Old 12-03-2005, 11:28 AM
Ron in SC's Avatar
Registered User
 
Join Date: Aug 2003
Location: Charleston, SC
Posts: 1,095
I replaced front shocks and rear strut assemblies when vehicle had 105K miles on it. Previously I had not had any alingment or uneven wear problems.
Reply With Quote
  #7  
Old 12-03-2005, 08:39 PM
Registered User
 
Join Date: Feb 2001
Location: California
Posts: 392
Quote:
Originally Posted by fema
Glad to see this post now as I am having similar issues and looking for a good tire this time around - here's the short story and questions:

* Tires, Michelin Cross Terrain or Nokian? I saw both recommended under the Tires forum; I am in big time snow country, but let me say that my stock Dunlops were fine and the best wearing compared to the Bridgestones I went to next. All season's have worked for me year round even in the toghest on-road snow conditions - a tribute to the AWD.

* Currently Bridgestone Dueller H/T's are wearing as you have described here; first the rear's along the outside while fron'ts seemed fine. Now, the fronts wearing on the inside badly - this after a new tie-rod end and alignement, but no rotation. They look a lot worse than tires should with only 15K miles on them.

* My observation, once I started having alignments, I've had to have them annually - just coincidence or the shocks as you've mentioned because they are original with 112K miles? Are the shocks/struts a DIY? - I've read to take care with the springs as they are loaded with force.

A great forum I concur!
Do you think your tire wear pattern changed over time? You said the rears wear along the outside edge while the front seem fine. Then the fronts wear in the inside edge?
__________________
Silver Honda Accord, 2006
Silver G500, 2003
Silver SLK-320, 2002
Black ML-320, 2000
Bule Porsche 993 Targa , 1997
Silver Merkur XR4Ti, 1987
Reply With Quote
  #8  
Old 12-03-2005, 09:16 PM
Registered User
 
Join Date: Jan 2003
Location: Fort Gratiot, MI
Posts: 35
I have a 2005 with 17,000+ miles and all 4 tires are worn and cupped on the inside edge. There are signs of cupping and wear on the outside edge, but only a slight amount. These tires have never felt right, but I think the alignment is out of whack all the way around. The tire people say I should have been running more pressure than the 2psi over recommended and that I should have rotated twice as often as MB recommends on these "high performance" tires. The tires are Dunlop SP Sport 5000, 275/55/17.
Reply With Quote
  #9  
Old 12-03-2005, 08:30 PM
Registered User
 
Join Date: Feb 2001
Location: California
Posts: 392
Quote:
Originally Posted by supradupe
Hey you are not alone. but first let me ask you how many miles do you have on your ML and are the shocks/struts original? I have similar issue with my 98 ML with 70k on the clock. I had an alignment done last year at about 64k and after about 5k miles of driving, I noticed the rear tires are wearing out on the outside faster while the fronts are still even. I did some searches on the internet and it seems the uneven wear is a result of the weak shocks on the rear. At 70k I am going to change them out and see if I could prolong the tires a bit. I too have the Michelin X-terrain and they are great tires. If your shocks are still original, this may be the culprit.

I have 35K on my ml. Don't drive it much except to go snowing. I have the Micheline 4x4 xpc ('xpc' or something that). Again the wear difference is not bad and most people will not notice it, but the tire had little lines molded in the tread pattern about the death 1mm deep it is still there on the inside thread but almost gone on the outside edge (so maybe it is wearing 1mm more on the outside compaire to the inside after 7k-8k miles).

Maybe I am just turning too fast .

I theory is that on double wishbone suspension over time when the springs lose ther orginal strength they would sag and wear more on the inside. Maybe over time it would just work out for me.

just like to hear what other people think.

blau
__________________
Silver Honda Accord, 2006
Silver G500, 2003
Silver SLK-320, 2002
Black ML-320, 2000
Bule Porsche 993 Targa , 1997
Silver Merkur XR4Ti, 1987
Reply With Quote
Reply

Bookmarks

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On
Trackbacks are On
Pingbacks are On
Refbacks are On




All times are GMT -4. The time now is 11:31 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2025, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2024 Pelican Parts, LLC - Posts may be archived for display on the Peach Parts or Pelican Parts Website -    DMCA Registered Agent Contact Page