![]() |
|
|
|
#1
|
|||
|
|||
Gilly and other Gurus Please help -ML not starting
Gilly and other Gurus Please help -ML not starting
i have a 1999 ML 320 140K miles on it and i live in Michigan (ann arbor area) i was driving back home last night and suddenly i lost power in the engine i mean even though i press gas its not going up Luckily i was just couple of miles from my house so i was able to get back to my house at 5 miles an hour . the vehicle is like in idle state even though i press the gas completely. Suprisingly THERE IS NO CEL light( The light didnt come up) i got back to my house and shut of the engine . leave it overnight and the next day i started it cranks up but doesnt start i have to turn the key back to shut of cranking.i hope its not the transmission. i did a lot of research on this message board and came up with things like MAF or CPS sensor or the Fuel Filter going bad . i have changed the MAF a year ago and fuel filter 2 yrs ago. i havent changed the transmission oils yet. one thing i suspect is i changed my air filter to K&N Oil based filter 6 months back and some one complained that the MAF goes bad for this filter. i can change the CPS and MAF ![]() but if it is bigger than that could you please suggest me a garage tha does repair ML's in Ann arbor area in MI My car is sitting in the Garage... so guys please help me out... Thanks in advance vamsi |
#2
|
||||
|
||||
When my CPS went out on my 430, it did the continuos cranking thing. No CEL either.
I did not have the driveablitity issue though. When it ran, it ran fine. Only when I tried to start it would the engine just keep cranking all by itself without starting. It would eventually stop cranking after a few seconds.
__________________
Thank You! Fred 2009 ML350 2004 SL600 2004 SL500 1996 SL600 2002 SLK32 2005 CLK320 cabrio 2003 ML350 1997 C280 Sport |
#3
|
|||
|
|||
Update..
it started today and i was drive to the shop at 10-15 miles an hour... when i press the gas it wouldnt accelerate...looks like the engine is not getting the fuel...
any help is highly appreciated thanks |
#4
|
|||
|
|||
Research "limp home mode."
|
#5
|
|||
|
|||
Problem Fixed
I took it to a mechanic shop driving 5 miles/hr and he connected the scanner and it read 2 error code P 161 and p 170
he replaced just the MAF Sensor and everything is fine Thanks Guys |
![]() |
Bookmarks |
|
|