Parts Catalog Accessories Catalog How To Articles Tech Forums
Call Pelican Parts at 888-280-7799
Shopping Cart Cart | Project List | Order Status | Help



Go Back   PeachParts Mercedes-Benz Forum > Search Forums
Reload this Page Search Results
Register ShopForum Gallery FAQ Calendar Today's Posts Search

Showing results 1 to 27 of 27
Search took 0.01 seconds. Search: Posts Made By: armkb
Forum: Diesel Discussion 01-08-2008, 10:33 PM
Replies: 12
Views: 1,387
Posted By armkb
No I have not had a chance to check the timing,...

No I have not had a chance to check the timing, planned on changing out the timing chain in the spring due to the high mileage. No have not checked the compression yet.

We do have winter blended...
Forum: Diesel Discussion 01-08-2008, 12:34 AM
Replies: 12
Views: 1,387
Posted By armkb
Cold Starts

Have a 1984 SD with 209k miles, runs strong, decent fuel mileage. My problem is anything below 15 degrees and it just wont start. Ive replaced the glow plugs, adjusted the valves, new battery,...
Forum: Diesel Discussion 09-06-2007, 08:10 AM
Replies: 2
Views: 1,148
Posted By armkb
Front End Squeak

What is the most common cause of the front end squeak on the 126 chassis? Have checked my ball joints, bushings, strut bushings, and they seem fine. I did have a leak at the oil cooler awhile ago...
Forum: Diesel Discussion 06-06-2007, 11:21 PM
Replies: 3
Views: 729
Posted By armkb
It does not open under power. Have to hand crank...

It does not open under power. Have to hand crank it open. Closes well under its own power. Didnt think about testing both end terminals at the same time. Sounds logical that if both are hot when...
Forum: Diesel Discussion 06-05-2007, 11:20 PM
Replies: 3
Views: 729
Posted By armkb
Moonroof

Been trying to get my moonroof working and was able to open it with the emergency crank socket. It closes by itself but does not open on its own. Checked the current at the connection by the motor...
Forum: Diesel Discussion 01-25-2007, 11:45 PM
Replies: 5
Views: 1,040
Posted By armkb
Tie Rods

Will be rebuilding my front end soon and am in the process of ordering the parts. My question is do I need to replace the tie rods in assemblys or can I order three lefts and three rights and reuse...
Forum: Diesel Discussion 01-25-2007, 11:02 PM
Replies: 5
Views: 920
Posted By armkb
Next time it happens I will try neutral and see...

Next time it happens I will try neutral and see if that works. How difficult is it to replace the bushings on the shifter?
Forum: Diesel Discussion 01-25-2007, 10:59 PM
Replies: 3
Views: 843
Posted By armkb
Power Steering Pump

1984 300SD- Have a small leak out the front seal on my power steering pump. The oil is being slinged off by the pulley. Is it a DIY repair or is it time for a rebuild unit? Pump works find, no...
Forum: Diesel Discussion 01-25-2007, 10:45 PM
Replies: 5
Views: 920
Posted By armkb
Question Starting Problem

Was wondering if you all can help!! Have a 1984 300SD that runs fairly well. Good compression... starts right up in the coldest weather so far this winter. But a few times lately when I go to start I...
Forum: Diesel Discussion 11-25-2006, 05:18 AM
Replies: 7
Views: 994
Posted By armkb
Leaking at the bottom seal a lot.

Leaking at the bottom seal a lot.
Forum: Diesel Discussion 11-25-2006, 05:17 AM
Replies: 17
Views: 2,480
Posted By armkb
Thanks for your responses and your concerns. I...

Thanks for your responses and your concerns. I know it is wrong to install the bolt upside down but is only a temporary fix till I can get the coil spring compressor and do it the correct way and...
Forum: Diesel Discussion 11-25-2006, 04:46 AM
Replies: 7
Views: 994
Posted By armkb
After all the fuss it still leaks. I did the...

After all the fuss it still leaks. I did the drain tube for the air cleaner after, thinking it was leaking also but the turbo drain still leaks. Dont know what else to do. Did I install the gaskets...
Forum: Diesel Discussion 11-21-2006, 10:48 PM
Replies: 17
Views: 2,480
Posted By armkb
Replaced mine the other day and also did it with...

Replaced mine the other day and also did it with out removing the spring as was suggested here. Figured out that no way was the bolt going to come out from the top under the spring perch. I tried for...
Forum: Diesel Discussion 11-21-2006, 10:23 PM
Replies: 7
Views: 994
Posted By armkb
Smile Turbo Drain

I finally got around to replacing the turbo drain, was hesitant about doing the job as I read many posts here about how difficult it was. Finally did it tonight and had some difficulty but all in all...
Forum: Diesel Discussion 11-14-2006, 08:21 PM
Replies: 17
Views: 2,480
Posted By armkb
Question What tool rental program are you referring to?

What tool rental program are you referring to?
Forum: Diesel Discussion 11-13-2006, 11:07 PM
Replies: 17
Views: 2,480
Posted By armkb
Guide Rod Replacement

Does anyone have any experience replacing the guide rod bushing in the lower control arm. Had a leak in the lower oil cooler line for some time prior to acquiring the car and it leaked all over the...
Forum: Diesel Discussion 11-06-2006, 11:23 PM
Replies: 5
Views: 861
Posted By armkb
I have it around 650-700 rpm's, so I dont think...

I have it around 650-700 rpm's, so I dont think that is it.
Forum: Diesel Discussion 11-06-2006, 07:19 PM
Replies: 5
Views: 861
Posted By armkb
Rack Dampner Bolt

Have a 1984 300SD w/188,000 miles and noticed my idle has been a little rough every now and then. Checked the rack bolt and realized it was almost all the way in. So I adjusted it out a ways and then...
Forum: Diesel Discussion 10-25-2006, 12:18 AM
Replies: 4
Views: 947
Posted By armkb
Lack of Floor Heat

:) Got a 1984 300SD with 188,000 miles. Car has been running like a champ lately. Seems to be getting better and better with time. My problem albeit small is I get no heat out of the floor ducts. Got...
Forum: Diesel Discussion 10-15-2006, 09:58 AM
Replies: 5
Views: 990
Posted By armkb
I have a 1984 300SD, in fairly decent shape with...

I have a 1984 300SD, in fairly decent shape with 186000 miles. Have done a lot of work so far and am near the end of going over the entire car and repairing what needs attention. Hopefully it will...
Forum: Diesel Discussion 10-14-2006, 09:35 PM
Replies: 5
Views: 990
Posted By armkb
Rear Wheel Bearings

:) Have ordered new rear wheel bearings, rotors and pads. I know the order for installing the brake components, but what is involved in replacing the rear wheel bearings. Replaced the front bearings,...
Forum: Diesel Discussion 09-19-2006, 12:06 AM
Replies: 6
Views: 1,027
Posted By armkb
Nope...still doesnt work. May try a new voltage...

Nope...still doesnt work. May try a new voltage regulator. Is there any way of testing the old regulator? If this doesnt work will have to eat it and buy a reman alt.
Forum: Diesel Discussion 09-18-2006, 10:15 PM
Replies: 6
Views: 1,027
Posted By armkb
I think I really did it this time. I was cleaning...

I think I really did it this time. I was cleaning all the connections to the alternator, and the brushes then ran the alternator by mistake with out it being connected to the main wiring. Did I fry...
Forum: Diesel Discussion 09-17-2006, 10:36 PM
Replies: 6
Views: 1,027
Posted By armkb
Alternator Light On

Have a 1984 300SD...today adjusted the valves...all were tight. Runs quieter now with somewhat more response. Cleaned the motor with engine cleaner and hot water...no problems.
Then drained coolant...
Forum: Diesel Discussion 08-09-2006, 11:33 PM
Replies: 5
Views: 985
Posted By armkb
Have checked the fittings and it is coming from...

Have checked the fittings and it is coming from the cooler. Ive been told by a local german mechanic that over time the thin aluminum in the cooler is susceptible to corrosion due to the higher acid...
Forum: Diesel Discussion 08-09-2006, 10:31 PM
Replies: 5
Views: 985
Posted By armkb
Oil Cooler Leaking

1984 300SD oil cooler is finally on its way out. Leaks to much now to chance driving and having a massive leak. Any ideas on where I can get a quality german made part at a decent price? Thought...
Forum: Diesel Discussion 08-03-2006, 11:57 PM
Replies: 5
Views: 1,287
Posted By armkb
Motor Lacks Power/Hard Shifts

Recently bought a 1984 300SD, w/183000miles. Body in good shape...few small dents very minimal surface rust. One owner and judging by the looks of the under carriage I dont think its ever been driven...
Showing results 1 to 27 of 27

 
Forum Jump


All times are GMT -4. The time now is 01:30 AM.

Contact Us - Mercedes-Benz Discussion Forum - Archive - Privacy Statement - Terms of Service - Top

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2026, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2024 Pelican Parts, LLC - Posts may be archived for display on the Peach Parts or Pelican Parts Website -    DMCA Registered Agent Contact Page