Parts Catalog Accessories Catalog How To Articles Tech Forums
Call Pelican Parts at 888-280-7799
Shopping Cart Cart | Project List | Order Status | Help



Go Back   PeachParts Mercedes-Benz Forum > Search Forums

Showing results 1 to 30 of 80
Search took 0.01 seconds.
Search: Posts Made By: 244brick
Forum: Tech Help 07-05-2023, 07:14 PM
Replies: 4
Views: 2,766
Posted By 244brick
w124 5-speed 717.430

Hey guys!

I recently manual swapped my m104 124 wagon with an 1986 717.430 gearbox.

I did my first test on the jack stands and it appears 2nd gear is shot. It just grinds when I release the...
Forum: Mercedes-Benz Performance Paddock 06-21-2020, 07:20 PM
Replies: 1
Views: 1,837
Posted By 244brick
M113 manual into S124

Looking to purchase a 5.4 m113 out of a w209 with a Crossfire/SLK320 6-speed gearbox.

What is the best option for engine management?

Also has anyone completed this swap without modifying the...
Forum: Southeast - US (AR,AL,FL,GA,KY,LA,MS,NC,SC,TN) 09-16-2018, 09:10 AM
Replies: 0
Views: 2,593
Posted By 244brick
Drivetrain partout M104

Swapping a v8. Selling the M104 and trans cheap. 152k
Forum: Tech Help 09-16-2018, 08:36 AM
Replies: 11
Views: 2,606
Posted By 244brick
I found what I believe to be a wheel speed sensor...

I found what I believe to be a wheel speed sensor unplugged. How do I reset the ABS or ecm? Disconnect battery?
Forum: Tech Help 09-14-2018, 06:59 PM
Replies: 11
Views: 2,606
Posted By 244brick
PS, I should also note that the upper wire...

PS, I should also note that the upper wire harness, ETA, and e-gas computer have all been updated to 1998.
Also I have CEL and ABS lights on that have not been scanned yet.
Forum: Tech Help 09-14-2018, 06:57 PM
Replies: 11
Views: 2,606
Posted By 244brick
S124/M104 rev limited at 4K while driving

I tried to search as much as I could so I didn't have to make a post but couldn't pinpoint a solution.

I know the rev limiter kicks in at 4K for park and neutral, however it limits most of the...
Forum: Mercedes-Benz Performance Paddock 08-29-2017, 04:06 PM
Replies: 22
Views: 11,263
Posted By 244brick
You can get a reverse sump pan, if you raise the...

You can get a reverse sump pan, if you raise the right hand side of the motor up enough it will clear the pivot arm. No steering or cross member modifications need to be done.
Forum: Mercedes-Benz Performance Paddock 08-17-2017, 07:12 PM
Replies: 22
Views: 11,263
Posted By 244brick
606 does have the rectangular ports I thought,...

606 does have the rectangular ports I thought, the 603 has round which matches up to the m103
Forum: Bodywork - Repair, Paint, Tools, Tips & Tricks 08-06-2017, 01:13 AM
Replies: 0
Views: 1,990
Posted By 244brick
Has anyone retrofitted W140 bumper covers to fit a 124?

I need to replace both front and rear bumper covers on my S124. The rear bumper is obviously difficult to find. I could get a set of W140 covers from the local yard for pretty cheap, and I feel like...
Forum: Mercedes-Benz Performance Paddock 08-06-2017, 12:59 AM
Replies: 22
Views: 11,263
Posted By 244brick
Turbobandit manifolds are expensive and they're...

Turbobandit manifolds are expensive and they're overseas. I've learned I can redrill a OM606 turbo manifold for the M104.
Forum: Mercedes-Benz Cars For Sale 07-18-2017, 04:40 PM
Replies: 0
Views: 638
Posted By 244brick
S124 trade for C124

I'm in Florida. If you want a 5-door, I want a 2 door. Let me know.
Forum: Mercedes-Benz Performance Paddock 07-18-2017, 04:32 PM
Replies: 22
Views: 11,263
Posted By 244brick
A V8 e34 getrag will bolt to an m104 with an...

A V8 e34 getrag will bolt to an m104 with an adapter plate? Where do I find the adapter plate?
Forum: Tech Help 07-18-2017, 04:30 PM
Replies: 9
Views: 1,029
Posted By 244brick
That transmission doesn't fail to shift as long...

That transmission doesn't fail to shift as long as i go easy. Reverse gear does seem a bit more delayed so that's obviously from the sitting as you say, but other then that the transmission feels...
Forum: Tech Help 06-12-2017, 09:05 PM
Replies: 9
Views: 1,029
Posted By 244brick
Bump

Bump
Forum: Mercedes-Benz Performance Paddock 06-12-2017, 12:36 PM
Replies: 22
Views: 11,263
Posted By 244brick
Hmm. Well there's no 400e's even for sale near...

Hmm. Well there's no 400e's even for sale near me... so I guess maybe I can build a tubular subframe and order a 400e sway bar and spindles, then maybe take the angle grinder to the firewall if I...
Forum: Mercedes-Benz Performance Paddock 06-12-2017, 09:43 AM
Replies: 22
Views: 11,263
Posted By 244brick
400e's are not easy to find. I did find however a...

400e's are not easy to find. I did find however a 94 e320 running for $250.
The engine bay should be the same aside from the core support and cross member no?
I think I'm gonna go LS3/T56. It's...
Forum: Tech Help 06-11-2017, 10:21 PM
Replies: 9
Views: 1,029
Posted By 244brick
Alright so, got her running. Let her warm up,...

Alright so, got her running. Let her warm up, took her for a easy drive for about 2 miles then let her rip to burn off some of that old gas. It redlines at about 4k before it even gets a chance to...
Forum: Tech Help 06-11-2017, 04:05 PM
Replies: 9
Views: 1,029
Posted By 244brick
Just got a practically brand new OVP relay from...

Just got a practically brand new OVP relay from the local UPAP for a whopping $1.51. Hopefully it does the trick.
Forum: Mercedes-Benz Performance Paddock 06-11-2017, 01:42 PM
Replies: 22
Views: 11,263
Posted By 244brick
Building a w124 drift car

I've been talking about doing this for a while and I'm ready to pull the trigger.

These are the options I was thinking...

M103 with a redrilled diesel manifold to run turbo at low boost....
Forum: Tech Help 06-11-2017, 12:36 PM
Replies: 9
Views: 1,029
Posted By 244brick
No I uprgraded it to a 98. I just put some...

No I uprgraded it to a 98.

I just put some gas in it, however I went to put the original OPV back in but noticed it was full of water. Has to be my problem. Probably explains why it was getting so...
Forum: Tech Help 06-11-2017, 10:50 AM
Replies: 9
Views: 1,029
Posted By 244brick
I don't have anyone to help me at the moment....

I don't have anyone to help me at the moment. I'll put some gas in it later and see what that does.
Forum: Tech Help 06-10-2017, 04:37 PM
Replies: 9
Views: 1,029
Posted By 244brick
1994 S124 crank but no start.

I have a 1994 e320 wagon, 149k
It sat for about a year. Was running when I parked it.
This is what I have done so far..
Poured fuel stabilizer in the gas tank
Replaced the fuel pump
Replaced...
Forum: Mercedes-Benz Used Parts For Sale & Wanted 05-11-2017, 09:58 AM
Replies: 4
Views: 584
Posted By 244brick
Wtb s124 rear bumper

In search of a 94-95 S124 rear bumper cover.
Let me know if you have any other parts as well.
Forum: ML, GL, G-Wagen, R-Class, Unimog, Sprinter 01-16-2017, 12:37 PM
Replies: 6
Views: 3,081
Posted By 244brick
So I did a little research and rummaging through...

So I did a little research and rummaging through various different threads. Looks like I can have blocks made to mount on the bottom of the struts, there's a company that makes coil spacers for the...
Forum: ML, GL, G-Wagen, R-Class, Unimog, Sprinter 01-15-2017, 11:04 AM
Replies: 6
Views: 3,081
Posted By 244brick
What about just some universal rubber spring...

What about just some universal rubber spring spacers and taller shocks and raised torsion bars?
Forum: ML, GL, G-Wagen, R-Class, Unimog, Sprinter 01-14-2017, 09:16 PM
Replies: 6
Views: 3,081
Posted By 244brick
😑 was looking for something a lot more hassle free

😑 was looking for something a lot more hassle free
Forum: ML, GL, G-Wagen, R-Class, Unimog, Sprinter 01-14-2017, 12:31 PM
Replies: 6
Views: 3,081
Posted By 244brick
Alternative springs for w163

Does anyone know the dimensions of the OEM springs on a 1999 ml320 and/or options for a taller replacement? Going to build an off-road toy out of one. I've read raising the torsion bars for the...
Forum: Mercedes-Benz Performance Paddock 09-26-2016, 09:58 AM
Replies: 13
Views: 3,985
Posted By 244brick
Got no response from that listing. Anyone do bell...

Got no response from that listing. Anyone do bell housing adapters to run a getrag or a T5?
Forum: Mercedes-Benz Used Parts For Sale & Wanted 09-25-2016, 11:45 PM
Replies: 8
Views: 601
Posted By 244brick
How much shipped? I have a s124, not sure if the...

How much shipped? I have a s124, not sure if the drive shaft is any different. Shouldn't be ..
Forum: Mercedes-Benz Used Parts For Sale & Wanted 09-25-2016, 04:21 PM
Replies: 8
Views: 601
Posted By 244brick
WTB manual transmission for m104

Looking for a manual transmission with pedal assembly or if anyone makes bellhousing adapters to fit something else..
Let me know, I can pick up anywhere within central Florida.
Showing results 1 to 30 of 80

 
Forum Jump


All times are GMT -4. The time now is 09:35 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2026, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2024 Pelican Parts, LLC - Posts may be archived for display on the Peach Parts or Pelican Parts Website -    DMCA Registered Agent Contact Page