Seat swaping
I'm trying to swap the seats out of a 92 190E 2.6 w/ an 87 16V. The passenger wires up just fine but I'm having trouble w/ the drivers seat. I'm thinking that its because the 16V has memory and the 2.6 doesn't. What i'm looking for is a wiring diagram that would help me to figure out which wire goes where. any help is appriciated,
Thanks, Chris |
You might find it easiest to swap the entire power seat control units (black box where everything plugs in). Both cars should use the same square connectors for fore/aft adjustment, backrest angle, tilt, and headrest.
I had a similar problem when swapping seats between a 1993 300E and a 1987 300D. |
Thanks....I'll take a look at the seat. But it would help me out alot if someone had a wiring diagram that I could look at.
|
I looked at it but the plugs are different. Is there anything else I could possibly do to get this to work?
|
Anyone know the answer to Chris' question?
|
All times are GMT -4. The time now is 09:49 AM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2024 Pelican Parts, LLC - Posts may be archived for display on the Peach Parts or Pelican Parts Website