|
|
|
#1
|
|||
|
|||
Seat swaping
I'm trying to swap the seats out of a 92 190E 2.6 w/ an 87 16V. The passenger wires up just fine but I'm having trouble w/ the drivers seat. I'm thinking that its because the 16V has memory and the 2.6 doesn't. What i'm looking for is a wiring diagram that would help me to figure out which wire goes where. any help is appriciated,
Thanks, Chris
__________________
http://www.190revolution.net/prem/Chris93/Signature.JPG |
#2
|
|||
|
|||
You might find it easiest to swap the entire power seat control units (black box where everything plugs in). Both cars should use the same square connectors for fore/aft adjustment, backrest angle, tilt, and headrest.
I had a similar problem when swapping seats between a 1993 300E and a 1987 300D. |
#3
|
|||
|
|||
Thanks....I'll take a look at the seat. But it would help me out alot if someone had a wiring diagram that I could look at.
__________________
http://www.190revolution.net/prem/Chris93/Signature.JPG |
#4
|
|||
|
|||
I looked at it but the plugs are different. Is there anything else I could possibly do to get this to work?
__________________
http://www.190revolution.net/prem/Chris93/Signature.JPG |
#5
|
||||
|
||||
Anyone know the answer to Chris' question?
__________________
http://www.benzworld.org/forums/imag...e_steering.gif 1998 C43 ///AMG 1999 C230 Custom 5-Speed Manual |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|