|
|
|
#1
|
||||
|
||||
tool for releiving preasure on valve spring
I was adjusting the valves on my 1968 280SL and noticed on of the nuts had been rounded off by the last mechenic. I know mercedes -Benz makes a tool to releive the tentsion on the valve spring when removing this part from the cam to replace the worren part.
Can someone tell me the part number for this tool. I know I did not speak to clearly but I cannot get the factory tool to budge this nut , so I think now it is a replacement job. Thank You Bob Geco 310-839-8337 work |
Bookmarks |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
W126 Valve Stem Seal replacement DONE! | donbryce | Tech Help | 19 | 07-28-2004 08:16 AM |
Valve cover gasket replacement – 95 E320. | 71Rcode | Tech Help | 0 | 03-10-2004 08:44 PM |
Valve Stem Seals Tool | rs899 | Diesel Discussion | 5 | 06-12-2003 11:38 PM |
Benzmac, Steve, someone, please share how an idle control valve fails. | Tinker | Tech Help | 37 | 07-15-2002 01:01 PM |
Valve Spring Compressor | Jim Anderson | Tech Help | 1 | 11-27-2000 07:44 PM |