|
|
|
|
|
|
#1
|
|||
|
|||
|
I am trying to fix my high idle in P and N
Is this the throttle position sensor connector (3 wires)? Do I measure the resistance on the cable or on the base? thanks
__________________
------------------------------------- 1988 mercedes 190e 2.3 AT 160k miles |
|
#2
|
|||
|
|||
|
That's the air flow sensor position indicator and connector. Physically trace the pigtail from the TPS to its connector, which should be in an accessible location. On my 2.6 it is above the #1 inlet runner.
The TPS on the 2.6 is three pole - ground, idle, and WOT, but some KE systems may only have a two pole TPS without a dedicated ground wire. You run the continuity tests on the TPS pigtail. You want to test the TPS, not the harness to the other end. Duke |
![]() |
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 603 IP control rod sensor connector | sixto | Diesel Discussion | 2 | 04-25-2004 03:46 PM |
| Wiring harness connector removal--Help! | Dirtywhitebenz | Tech Help | 6 | 04-16-2004 12:43 PM |
| How to remove Coolant Temp Sensor’s connector? | Joseph_H | Tech Help | 5 | 11-09-2003 10:11 PM |
| Diagnostic Connector Differences? | KenP | Tech Help | 2 | 03-10-2003 04:09 PM |
| 1432 8Pin DIN connector | TCCBass | Car Audio and Multimedia | 9 | 03-08-2003 02:23 PM |