|
|
|
|
|
#4
07-11-2005, 09:15 AM
|
|||
|
|||
|
46mm on the nut and 41mm on the driveshaft. I used a two arms puller for the center bearing. It came out easily, and I guess (as others posted) you can do it with a hammer as well.
Bruno
__________________
_ 1992 300TE 160 kmiles 
|
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Sun Roof -what is thread size of nut ? | tino | Tech Help | 1 | 05-20-2005 09:02 AM |
| Size of nut on rear of trans. output shaft? | Jetmugg | Diesel Discussion | 3 | 05-08-2005 01:33 AM |
| Bosche KE FI Manual | BAd124 | Tech Help | 27 | 11-13-2004 10:10 AM |
| what size nut do I need? | pkmorgan17 | Diesel Discussion | 1 | 06-27-2002 01:23 AM |
| Remove Nut or Nut, bolt and Sleeve on P/S Fluid Reservoir? | Steve Gutman | Tech Help | 1 | 05-16-2002 02:05 PM |
Threaded Mode
