|
|
|
|
|
#1
02-15-2001, 11:48 PM
|
|||
|
|||
|
On my W123 body (Diesel Motor)
Crack approx. 2 “ length has been found on big cross beam. This big cross beam is welded between left frame and right frame and located under engine near oil reservoir. How can I repair this crack by gas welding? I think electric arc welding is not acceptable because may be arced between engine bearing and crankshaft or on bearing wheels etc. 
|
|
#2
02-16-2001, 08:20 AM
|
|||
|
|||
|
see my reply in Diesel Discussion.
Best of luck,
|
 |
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Did someone drive their 87 300D W124 300 miles with a cracked head? | Carrameow | Diesel Discussion | 3 | 10-26-2004 02:06 PM |
| Why can my 85 300D climb the Shenandoahs but not cross the street... | Carrameow | Diesel Discussion | 16 | 07-09-2004 06:33 PM |
| 300D w123 hirschmann antenna | nibiru | Car Audio and Multimedia | 3 | 06-22-2004 12:40 AM |
| Why did the chicken cross the road? | Joseph Bauers | Off-Topic Discussion | 7 | 05-28-2004 12:47 PM |
| w123 300D cross beam cracked | 300D | Diesel Discussion | 2 | 02-19-2001 02:07 AM |
Linear Mode
