2000 S500 Where is the fuse for the driver door controls at?? - PeachParts Mercedes-Benz Forum

Johnny916 · #1 12-19-2005, 05:48 PM

Hi, all my drivers door controls have seem to went out. I suspect it's a fuse but where should I check the fuse at? Is it located in the engine area or somewhere in the car?

#2 12-19-2005, 06:13 PM

Quote:

Originally Posted by Johnny916

Hi, all my drivers door controls have seem to went out. I suspect it's a fuse but where should I check the fuse at? Is it located in the engine area or somewhere in the car?

it is likely that the door control module has failed, did the door get wet inside?

Johnny916 · #3 12-19-2005, 06:18 PM

Heeey what should I do now?? I just got my windows tinted and now nothing on my drivers door seems to work! What should I do now? Am I supposed to sue the tinting place? How can I prove it was them? Should I have it fixed first??

Gilly · #4 12-19-2005, 06:20 PM

Maybe they decided to pull the door panels to do the job and didn't get the control module plugs reconnected?
Gilly

Johnny916 · #5 12-19-2005, 06:24 PM

I seriously doubt they took 2 hours to take the door panel off but regardless the windows did roll down once or twice before I heard a clicking noise then the windows rolled up and everything on that door went bad!! ALSO, you're not going to believe this but the ABS light went on shortly after and now I can't even get my car out of Park! There was also a stability control error!!

Gilly · #6 12-19-2005, 06:32 PM

I guess at this point, if you look in the owners manual, it tells you how to get the shifter out of park in an emergency, hopefully the trans will shift OK. I'd want to get it to a dealer for diagnosis, tell them the circumstances and see if they can nail down the cause for you and go after the tinting shop if they were at fault.
Gilly